Do you ever write eScript in Siebel ???
With never versions of Siebel (7.8+) Siebel introduced the ST Scripting engine. It contains a lot of changes, and Siebel may have jumped the gun a little by actually supporting ECMAScript revision 4, before the standard was finalized, but the information about the compliance is not to be found anywhere in the documentation, or supportweb....
I recently had the chance to discuss the subject with a very knowledgeable Support Engineer, that i have had the pleasure of working with on many occasions. Here´s his reply to my question:
Q) "Which version of ECMA-262 is Siebel eScript based on?"
A) "Siebel eScript in Siebel 8.x is based on ECMA-262 version 4. This version actually never made it past the proposal status, as mentioned on Wikipedia:
This fourth edition proposal contained new language features like static typing, which were adopted by Siebel eScript, to make scripts faster and also more robust against the typical programming errors associated with dynamic typing.
While the ECMA-262 version 4 proposal has vanished, eScript continues to provide these new features.
Siebel eScript does adhere to ECMA-262 as much as possible, but subtle differences may always occur, and this is more likely for ECMAScript features that are not documented in Siebel Bookshelf."
Here is a link to the standards definition (note that this may or may not be the features supported by the Siebel implementation of ECMAScript 4...).
Welcome to Installing Oracle 11r2 on Windows 2008R2 Server Part 2 of the series
"Doing a Complete install of Siebel 220.127.116.11 on Oracle 11 r2, Win 2008R2. All from Scratch"
In this part we will configure an oracle database server. This server will house a development database, and a test database. This walkthrough will focus only on the development database installation.
To Install an Oracle database we will go through the following steps
- Install the Oracle Database Software This was completed in Part 1 Here
- Configure the Oracle Database
- Configure the Listener
- Verify & Configure Windows Services
- Configure Windows Firewall
- Do Connectivity Tests
To Configure an oracle database you need to run the dbca from a command prompt. Follow the screenshots, and step guide below to configure the database for use as a Siebel development server.
We need to install a Custom Database, as we need to configure advanced properties. Hit Next